Posts Tagged ‘Container’

Fabrication Time

Posted: 29th August 2012 by asteriskr in Rallye 16v, Welding
Tags: , , , , , , , , , ,

Well had a bit of time away and a chance to get perspective and decide what I wanted to do with the car. Came back with a bit more enthusiasm and then tonight managed to get a good few hours working on the car. Fabricated up some mounting points for the retaining straps that are going to hold the fuel cell in. These are going to be strong. Welded M8 nuts onto some 3mm plate and then welded that to some SWG16 sheet which I then folded and welded up. Might have played with the swager set in the process…

fabrication

fabrication

fabrication

These pair of bad boys will be welded in behind the fuel cell in the hollow where the rear seats used to be and will sit flush at the same level as the boot floor. Then just need to mount the other two plates onto the bulkhead and form up a template for the retaining strap out of some steel and then I’ll get some made up out of 5mm alloy.

Update

Posted: 5th July 2012 by asteriskr in Rallye 16v
Tags: , , , , , , , , , , , ,

Finished the Fuel Cell Framing last week and it’s now in a base coat of POR15. Since then I’ve been doing some tidying up elsewhere on the shell, such as removing the studs that had held on the fusebox. The heads of these are real rust traps in the wheel arches so there was some rot to cut out. All tidied up and in primer now.

I’ve also taken delivery of a pair of chassis rail gussets from 106parts. I fabricated what was neded for the repair on the 8v but the whole panel needs replacing on both sides so it was the only sensible thing to do as they’re not simple shapes. These are genuine Peugeot/Citroen panels rather than after market supplied ones and are the first repair panels I’ve purchased.

Chassis Rail Repair Panels

Chassis Rail Repair Panels

Spoke to the machine shop yesterday, they haven’t started on the column yet and are closed for two weeks from Monday on holiday so could be soe time before that’s ready to collect for welding.

In the mean time I’ve been amassing a selection of items to crack on with some wiring. This includes more Raychem DR-25 heatshrink and some inline butt slices. The challenge is a neat way of connecting and terminating the coiled lead that will connect the steering wheel controls to the loom. Due to the use of relays the wiring is all signal cables so very fine cable (SWG26) which doesn’t have much substance with which to work, but still needs to be connected up to the ITT Cannon Neptune connectors.