Posts Tagged ‘Point’

Dash for Progress

Posted: 5th September 2012 by asteriskr in Rallye 16v, Welding
Tags: , , , , , , , , , , , , ,

About to become exceptinoally busy with work which will put a dampner on much progress in the coming month or so and as a result I am trying to make a bit of a push on the car. I suspect the biggest development is to finally decide the direction for the build, which is now intended for stage rallying. So with that in mind picked up a few more bits Peugeot Sport France (PSF) style sumpguard and mounting that will need to be welded onto the front of the car.

Sumpguard

Sumpguard

Wilwood hydraulic handbrake conversion kit was next. The current handbrake has now been drilled with a 2.5mm hole uinto which a locking pin (bit of stainless steel bicycle spoke) can be insterted to make it a fly-off lever by disabling the ratcheting mechanism and will now need a tab welding on so that the bracket that drives the piston can be attached. I need to have a look at leverage ratios to make sure I mount it properly.

Hydraulic Handbrake

Hydraulic Handbrake

My friend Stu who makes a good living out of welding day in day out kindly did the honours on my EPAS column:

Which has meant that I can reassemble the unit and get it back in the car. I just need to finish assembling it with the support bearing and tube that fits near to the boss. What a mission this has been.

EPAS

Welded in the rear mounts for the fuel cell container – the alloy for the retaining straps turned up today too. Looks a bit messy at the moment, but it will clean up nicely.

Fuel Cell Mounting

Every Little Bit

Posted: 18th June 2012 by asteriskr in Rallye 16v
Tags: , , , , , , ,

Removed some more surplus bracketry from the car – these were the rear seatbelt reinforced mounting points.

Photo