Finished the repair on the nearside inner wheel arch. I need to grind down and finish up these welds then seam weld this side of the engine bay. Then there's the repairs on the section where it joins onto the chassis rail, but the chassis rail shouldn't need any work. I also managed to pick... Continue Reading →
After some use I have to say that the Tungsten Carbide die cutters are amazing. Even just used in the Dremel I'm not sure how I'd missed out on them this far but they have transformed my metal working. They're also going to save me a fortune in Dremel attachments. Jed was right with his... Continue Reading →
Really unproductive weekend. Probably managed 3 hours on the project... Chopped out some more rotten bits. I'm happy I've got to the bottom of the problem areas now, so started making up repair sections. When it's all put back together this section creates a water trap on top of the chassis rail. There was really... Continue Reading →
Little update as work slowly progresses. This is a rather complex shaped gusset that sits within the chassis rail acting as a support. It curves in all three axis. Mine was so rotten it had to come out and I fabricated this replacement out of sheet steel, it just needs finishing off and prepping for... Continue Reading →
Finally managed to get back to this. Having managed to get my hands on a sheet metal folder, I set about making the reinforcement gusset to sit inside the chassis rail. Starting point was a cardboard template which was transferred onto steel and shaped to give the initial shape. The chassis rail curves in the... Continue Reading →
Worked out what that row of spot welds were for... ... the internal chassis rail reinforcing gusset was very rotten though so chopped it out... Pretty much all of the roof of the rail which is thinner SWG20 is badly rotten - it actually went to holes as I cleaned it up with a twisted... Continue Reading →
Rallye Project 