Handbrake Reinforcement: Trying to repair the mess on the parts of the tunnel I mentioned last time just left me chasing holes in the affected sections. So despite getting it looking pretty good, it was full of thin metal sections and pin holes. The underside told the true story - things were not good. Only... Continue Reading →
The problem with working on the exhaust tunnel is that you need to be able to get to both sides of it and the underside is a pain to work on. It would make sense to have a facility to be able to turn the car on its side but that's not an option. So... Continue Reading →
After a lot of hours I have the majority of the engine bay in POR15 primer. I've left the lowest sections of the bay in a rough state because there still some work to do to bring the shell back to bare metal and treat it properly with POR15. The next job will be to... Continue Reading →
After a bit of a pause in which not much happened on either car, some nice bits have arrived for the 16v which means that I can press on and get some bits finished off. I have to think ahead on a lot of different levels about how things will fit together and work once... Continue Reading →
Things have run into a snag on the EPAS. The background here is that I am putting a Vauxhall Corsa electric power steering (EPAS) unit into my Peugeot 106. The connection between the end of the EPAS and the pinion on the rack is tight for space (about 5"). I have tested things out by... Continue Reading →
The other little thing I have been working on is the bypass for the heater matrix coolant pipes. Prior to deciding to take out the heater setup I had bought a set of the Baker BM silicone hoses but they were now surplus to requirements with the new heater less setup. So they've been chopped... Continue Reading →
I haven't been sitting idle recently, I've just not had a lot of time for getting on with the chassis. New wire for the welder turned up end of last week after a bit of a wait (I am fussy about what I use): With it I was able to finish off the reinforcement of... Continue Reading →
Well I haven't posted much on the 8v recently, but it's getting daily use during the week as the Nursery wagon. There are a few things that now need a little attention. I stuck a new rear wiper blade on a few weeks ago as the one that was on the car may well have... Continue Reading →
Photo of the finished box in the scuttle for the wiper motor. Spent a bit of time cleaning up some of the recent welds. Here is the blanking plate over where the heater motor air inlet was. Next job is to modify the steering column support so that I can get the welding in this... Continue Reading →
Bit more progress today... Fabricated up a box for the scuttle. Test fitted Welded up Tacked in place after this it was ground down to fit. I thought that I'd taken some pictures of it all welded up, but seems not. Also put the bonnet back on to show the clearance...
With the Christmas festivities out of the way and with a few days before needing to be back to work, it has been an opportunity to press on with the project. Previously I had fitted a Citroen AX single wiper conversion to the car. The initial fitment had just made use of some of the... Continue Reading →
Well managed an hour tonight, looking forward to getting some quality time on this over the next few weeks. Seeing as I am going down the heated windscreen route and have stripped out the heater matrix and blower, there was another hole to fill in the bulkhead. Stitched the steering rack support whilst I was... Continue Reading →
Rallye Project 