The plastic spot welds on the rear bumper that holds the inner to the outer had broken on about 8 out of 10 so I gave it all a good jet wash and then once it had dried out used some Tigerseal to bond the outer skin to the inner structure.
The two tabs that allow the two sides to be bolted to the shell were broken. One was missing. This one that was left was hanging on by a thread.
Worked out the dimensions and ordered some carbon box section and some more u-nuts. Chopped and drilled ’em.
Two-part epoxy to bond the scuffed up carbon to the scuffed up plastic.
And bonded on…
Leave a Reply